The fischer termoz CNplus is ideal for securely fixing pressure-resistant insulation up to 340 mm thick, such as polystyrene boards and mineral wool boards. The European Technical Assessment guarantees secure hold and regulates the use in all building material classes and insulation types. The termoz CNplus is set with a hammer. Alongside the small drill hole depth, this saves time and money during installation. However, it can also be screwed into the anchoring base. The flexible hammerset is placed exactly flush to the surface or countersunk, depending on the desired application. The termoz CNplus can also be adjusted with the screwdriver and removed without problems.
termoz CNplus is a hammerset anchor with the option to be screw set. The plug is suitable for all building material and insulation types. Through the flexible use the warehouses and ordering processes are reduced.
With the fast and simple hammerset installation the plugs set too deep can be readjusted with the aid of the screwdriver. This saves working time and helps to avoid fixing marks.
During the screw installation the termoz CNplus can be set countersunk or flush. For different set results only one plug is required.
Moreover the screw installation enables an accurate setting due to an optimum application on the insulation surface. Also with soft insulation.
The compound nail ensures a high energy efficiency with the countersunk screw installation, because there is nearly no heat transmission.
Application and Permission
Attachment of ETICS insulating boards on concrete and masonry
Flush installation in ETICS insulating boards, e.g. polystyrene and mineral wool
Countersunk installation in ETICS insulating boards, e.g. polystyrene and mineral wool, incl. a closing cap for covering
Building material classes A, B, C, D, E
Full blocks made from concrete
Solid sand-lime brick
Hollow blocks made from lightweight concrete
Vertically perforated brick
Perforated sand-lime brick
Lightweight aggregate concrete
You can find detailed information on building materials in the registration document.
DoP No. 0091
For Details see corresponding Documents
The plug is set in push-through installation.
Simple, fast setting by driving the compound nail in using a standard hammer.
The setting process with the screwdriver is performed flush with a standard Bit T 25.
For countersunk installation the setting tool CNplus is required. The insulation disk is covered with a closing cap.
Non-load bearing layers, such as adhesive and old plaster, are included in the maximum useful length.